Mottled Ochre Stoneware Glaze Powder BP36P

Product Description

Finish : Satin

Firing Range : 1250°C - 1280°C

Mixing Ratio:  1.1lt :1kg

Mixing Powdered Glazes:

• Always wear a mask when mixing powdered glaze.


• Gently add the glaze powder to water in a bucket, avoid adding all at once to prevent clumping.


• Mix glaze using either a hand or electric whisk for 10 minutes


• Sieve the liquid glaze using an 80 or 100 mesh sieve, working all the material through the sieve using a stiff brush.


• The glaze mix should have a creamy viscosity, remember it’s easier to thin a glaze so begin with a thicker mix than you expect.


• Although all our glazes are and non-toxic, it is essential in any pottery studio to minimise inhalation of silica dust. Always clean up with a damp sponge and if any dust is airborne, such as when mixing powder glazes.

Glazes that have a low clay content do tend to settle more quickly. We find that adding a small amount of calcium chloride liquid (one or two tablespoonfuls per gallon) is helpful. Do be careful however, not to overdo the calcium chloride as this can lead to a fault known as 'plucking' in which the glaze cracks and pulls away form the body during firing. Do NOT use the calcium chloride with the BP16P Orange Red, or BP18P Tenmoku. These both contain bone ash and the calcium chloride react with it to form a very hard layer at the bottom of the bucket.

View other products in Bath Potters Stoneware Glaze Powders »