Rigidiser

APPLICATIONS PROCEDURE
Hardener is normally used diluted 50-50 with water and
can be applied by brushing, spraying, or dipping. Spray
operation should be carried out under well ventilated
conditions, taking care to avoid breathing in the spray.

The amount needed varies with the type of application,
and is dependent on variables such as Blanket density
and the depth of treatment required. As a surface coating,
2.5 litres of diluted Hardener will cover 1m2, and 17 litres
will saturate the same area of 25mm @ 128kg/m3
Blanket.

Drying procedure is not critical but 12 hours at 90 C is
fairly typical. Natural drying is feasible but, in the case of
through-hardened Blanket or Board, migration of
Hardener to the material surface may occur.