Batt Wash
Description
This product will prevent drops of glaze from sticking to the bottom of the kiln or the kiln shelves. The wash binds with the glaze to make a brittle material that can easily be scraped off. It is recommended that the shelves be coated with a new coat of wash before each firing.
Kiln shelves are quite expensive, so anything you can do to save them is well worth it!
- It is made by mixing with 60% water and applied with a brush to form a layer 1mm thick.
- The consistancy is similar to that of melted ice cream.
- If your glazes do not run, one coat of batt wash should be enough.
Health & Safety & Disposal
- When handling powdered ceramic materials, you must wear an FFP3/P2 face mask and nitrile gloves to prevent inhalation and skin contact.
- Wear a wipeable apron, polyester overalls, or similar. Clean or wash frequently.
- Always clean your studio with a wet sponge rather than sweeping to stop dust from becoming airborne.
- When preparing glazes, add the dry material to water, not vice-versa, to minimise dust formation.
- Do not allow eating and drinking in the studio and thoroughly wash hands when leaving.
- Never eat, drink, or apply cosmetics in areas where clay or glazes are handled.
- Ensure emergency eye-washing facilities are available in the room.
- Review official guidelines regarding studio ventilation and chemical management routinely.
In the UK, wet clay and liquid batt wash (often made from alumina, kaolin, or silica) are generally non-hazardous during transport and routine handling. However, if they dry out and create dust, they carry a Specific Target Organ Toxicity (STOT RE2) hazard due to breathable silica/quartz content.
Dispose of as normal industrial waste, in accordance with local/regional/national/international regulations.
Customer Reviews












Share
Batt Wash
Facebook Twitter Email Pinterest Telegram